Quick Start Guide

ManualsBrandsLEEDARSON LIGHTING ManualsElectrical EquipmentDIMMER

WARNING:

• This product is to be installed or used in accordance with electrical codes and

regulations.

• For indoor use only. Do not use in wet locations.

• If you are unsure any part of these instructions, consult an electrician.

• Save this instructions sheet. It contains important technical data along with

testing and troubleshooting information which will be useful after installation is

complete.

• This dimmer are not compatible with standard 3-way or 4-way.

• Do not disassemble the product, or make repairs yourself. You run the risk of

electric shock and voiding the limited warranty. If you need service, please

contact the after sales services.

• The load power rating limit of the device as below Specification sheet, do not

exceed the limit.

Package Contents

Smart dimmer *1

Quick start guide*1

Accessories package*1

Product Description

The dimmer turns your light smart by enabling you to control them through the smart

home APP on your phone at or away from home.

Summary of content (8 pages)

PAGE 1
WARNING: • This product is to be installed or used in accordance with electrical codes and regulations. • For indoor use only. Do not use in wet locations. • If you are unsure any part of these instructions, consult an electrician. • Save this instructions sheet. It contains important technical data along with testing and troubleshooting information which will be useful after installation is complete. • This dimmer are not compatible with standard 3-way or 4-way.
PAGE 2
Specification Model number Power supply: Maximum Load： Operational temperature: Storage Temperature Range Humidity Radio protocol: Range: HDA11FWB 120V~, 60Hz Incandescent 200W, CFL/LED 100W 0-40°C -20-60°C 0-85%,non condensing 2.4G, IEEE 802.
PAGE 3
Installing dimmer by itself or with multi-gang If installing the dimmer in a single gang application, proceed with Product install introduction. If installing the dimmer in a multigang application, proceed with follow: Multi-gang application In multi-dimmer installations, the reduction of the dimmer’s capacity may be required. Refer to the chart for maximum load per dimmer. Note: No derating is required for LED or CFL bulb applications.
PAGE 4
PAGE 5
3. Mount the dimmer using the screws and attach faceplate. 4. Turn power ON at circuit breaker 5. Quick start guide Step 1: Download the Linkind App on App Store or Google Play. Step 2: Create an account and sign in.
PAGE 6
Step 4: Follow the instructions on App. LED Indicator Under normal working state. LED indicator is solid green— turn on or dimming, LED indicator is off —Turn off. Status Behavior Green and Orange To be configured status. scrolling blinking Quick Blinking Orange Connecting to the network Solid Green Solid Red Off Connected to the network The smart dimmer is turned on or dimming Connected failed.
PAGE 7
Troubleshooting Problems Possible cause and action LEDs do not dim, have Lamp is not compatible with the dimmer poor dimming Please check from the official website to see if the range, or they flicker/buzz. load is an officially declared compatible lamp. Lights Flickering Lamp has a bad connection Wires not secured firmly under terminal screws of switch Light does not turn ON Circuit breaker or fuse has tripped. and LED indicator does not Lamp is burned out. turn ON Lamp Neutral connection is not wired.
PAGE 8
receiver is connected. -Consult the dealer or an experienced radio/TV technician for help RF Exposure Statement This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance of 20 cm between the radiator and your body.