LED User Manual Model: y-A880ST-Q1R-xx Electronic Data Parameter Units Min. Rated Max. 90 120 132 Supply Voltage V Supply Frequency Hz 60 Supply Current mA 88 Power Consumption W 8.5 Power Factor - 0.9 Drive output voltage V Drive output current mA 9.5 Remark 10.5 48 153 170 187 LED Data LED Model - 3535 LED Circuit Mode - 8S2P LED Vendor - / Chromaticity Data Parameter Units Luminous Flux lm Max Luminous Intensity cd Beam Angle ° Luminous Efficiency Min.
% 5 100 Light Distribution Curve Parameter Min. Units Rated Max. Remark IEEE 802.15.4 Standard GHz 2.4 Protocol - 2.4GHz ~ 2.5GHz ZigBee HA 1.2 Effective Indoor Connection Range m 40 Wireless frequency Operating Frequency Wireless IC NXP JN5168A Wireless Module Part number A470S-A7R-01B Antenna PCB Antenna In door direct range, no walls or other obstacles in between. Operating Condition Parameter Units Min. Rated Max.
Drawings mm State 1 Factory state 2 The match state 3 Network status 4 Turn off the lights action 5 From the network state 6 Reset action Behavior description Fast 2 flashes, keep constant light (max 1 flashes Adjustable lighting, each power up both to maintain the brightness of Max Within 1 second down to the dark after the close 1 flashes, into the dark. And not the net, to re join the new network, you need to supply a. Fast switch 5 times, power on time maintained at between 0.5‐2 seconds.
FCC Warning This device complies with Part 15 of the FCC Rules. Operation issubject to the following two conditions: (1) This device may not cause harmful interference, and(2) this device must accept any interference received, including interference that may causeundesired operation. NOTE 1: Any changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.