Building your success in IoT Smart Plug-NA (ZigBee) User Guide
WARNING: For indoor use only. Do not use in wet locations. The total current limit of the device is 15Amp.To avoid damage, Do not exceed the 15 Amps limit. If a direct short is created on the output, the Smart Plug will be damaged and no longer function. Do not disassemble the product, or make repairs yourself. You run the risk of electric shock and voiding the limited warranty. If you need service, please contact the after sales services.
Specification Power supply: 120V~±10%, 60Hz Rated load current: 15A Power consumption: ≤1W Power output 1800W Operational temperature: 0℃-40℃ Radio protocol: Zigbee 2.4G Range: About 40m indoors (depending on building materials) Led indicator LED Indicator: Under normal working state, Green-on, Red-off.
Installation Please note:This Plug is a Zigbee plug, Zigbee hub is required. Before to setup plug, please make sure your Zigbee hub is working well. Add Smart Plug 1. Click “Settings,” “Add device,” then, “Smart device.
2. Press and hold the Reset button for 5 seconds, the indicator will flash quickly, release the button and the light will flash twice. 3. The LED will stop blinking and will remain on, only after it successfully connects to the gateway. 4. The Smart Plug status can be found in “Settings”, “Device-management”, Smart Plug.
5. Press the Smart Light icon to turn the device on or off; press and hold on the icon will open the device control interface.
6. When in this mode, the user can view the current electricity load status, electric usage, and set the timing operation. (Timing function is being upgraded) 7. Tap the “settings” icon. The plug can now be named and the room group assigned. This is also where a device can be deleted.
Create Room 1. Enter the “Room” set up page and tap to create a room. 2. In “Modify room,” the user can edit the room name, the room icon, or add a device.
3. Press and hold on the icon to control the device on or off; pressing the icon will enter into the device control interface. Set your Scene 1. In the “Scene mode,” press to activate scene; Press and Hold to edit.
2. Tap to “Create Scene”, enter your Scene name, and your Scene action, by asking “if this… ”“then this… ” The scene can also be interactive with other devices.
Shortcut 1. The shortcut is designed to link to room, scene or device that is used often. Tap to add shortcut. 2. Existing Room, Scene and Smart Device can be linked to the Shortcut.
Settings 1. Device management operates the devices that have been added to the App.
2. Tap device icon to control device on/off, press and hold to enter to the Device Edit Interface. Safety information 1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference.
(2) This device must accept any interference received, including interference that may cause undesired operation. Note: The grantee is not responsible for any changes or modifications not expressly approved by the party responsible for compliance. Such modifications could void the user’s authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
4. Consult an experienced technician for help RF Exposure Statement This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 8 inches (20 cm) between the radiator and your body. IC Statement This device complies with Industry Canada license-exempt RSS standard(s).
uncontrolled environment. This equipment should be installed and operated with minimum distance of 8 inches (20 cm) between the radiator and your body. -----------------------------------------------------------------------------------------For more information, Welcome visit: www.leedarson.com. Mail to: iot@leedarson.com LEEDARSON LIGHTING CO., LTD.