Safety Information

7
6. Maintenance
① How to reset a door/window sensor?
Keep pressing the reset key about 3 seconds, then the LED indicator will start blinking quickly. Once
release the key, the sensor will reset to factory setting and the LED indicator blinks once per second to
search a new enabled network.
② How to join a door/window sensor?
After the sensor is reset to the factory setting, the signal light blinks once per second and sensor starts
searching an enabled network. If sensor enrolled successfully, it will stop blinking and stay on for 10
seconds. If no available networks were found within 3 minutes, sensor will stop blinking and turn off.
③ If need to clean the sensor, please use a soft cloth with a little alcohol to wipe it after you cut off the
power.
④ This product is just for indoor use only.
⑤ Please well-Installed the sensor on the bracket. If it is not well-mounted, it may report anti-tamper.
⑥ Replace the battery timely on low battery warning to ensure the detector works properly. Please use
battery model CR2450 only.