Quick Start Guide

Bypass switch

YES

Certifications

CE/FCC

2. Product Installation

This product can be mounted by screws or 3M adhesive tape, install it according to the following step:

① Remove the plastic sheet for isolating battery from battery cabinet.

② Use a pin to reset the pinhole switch for 3 seconds to reset the sensor. The sensor will be in pairing status.

This will cause a LED indicator to flash once per second. If sensor enrolled successfully, it will stop blinking

and stay on for 10 seconds. And then the LED will be turned off. 4

③ Stick the slim magnet and device onto the door/window, no further than 20 mm from the sensor, fix the

device on the door/window by screw or 3M tape.

④ The magnet and the main sensor must be less than 20 mm apart. Main sensor must be affixed to the

frame and the magnet must be affixed to the door window.

⑤ Should not be mounted on a metal frame.

3. Safety Information

IMPORTANT: Do not expose to rain. Install the product at least 3 ft. from the oor for optimum performance.

This alarm contains small parts and is not suitable for children. Periodically check the condition of the

batteries.

Disposal and Recycling Information:

Correct Disposal of this product. This marking indicates that this product should not be disposed with other

household wastes throughout the EU. To prevent possible harm to the environment or human health from

uncontrolled waste disposal, recycle it responsibly to promote the sustainable reuse of material resources.

To return your used device, please use the return and collection systems or contact the retailer where the

product was purchased. They can take this product for environment safe recycling.