Quick Start Guide

4
4. Maintenance
① How to reset a door/window sensor?
Keep pressing the reset key about 3 seconds, then the LED indicator will start blinking quickly. Once
release the key, the sensor will reset to factory setting and the LED indicator blinks once per second to search
a new enabled Zigbee network.
② How to join a door/window sensor?
After the sensor is reset to the factory setting, the signal light blinks once per second and sensor starts
searching an enabled Zigbee network. If sensor enrolled successfully, it will stop blinking and stay on for 10
seconds. If no available networks were found within 2 minutes, sensor will stop blinking and turn off.
③ If need to clean the sensor, please use a soft cloth with a little alcohol to wipe it after you cut off the
power.
④ This product is just for indoor use only.
⑤ Should be affixed indoors and away from sources of moisture.
⑥ This product has low voltage detection reminder. When the battery voltage is in low status, the sensor
will give out low battery signal to gateway.
⑦ Replace the battery timely on low battery warning to ensure the sensor works properly. Please use
battery model CR2 only.
7.1 Remove sensor from bracket (Fix bracket and move sensor up)
7.2 Replace battery if battery is low power.
5. FCC compliance notice
FCC ID：2AB2QM604ENTRY
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)
this device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
FCC Caution:
Changes or modifications not expressly approved by the part responsible for compliance could void the user's
authority to operate the equipment.