Installation Notice

5
2. Install the detector where there is a concern for a potential water leak.
7. Product usage
1. Insert 2 pcs AAA battery to the battery space, and the water leak sensor will be ready for use.
2. How to reset a water leak sensor
A. Press and hold the reset key on the bottom cover for about 3 seconds, then the LED
(signal light) will start blinking quickly.
B. Release the reset key and the sensor will be reset to factory settings and the LED(signal
light) blinks once per second to search for a new enabled Zigbee network.
3. How to pair a water leak sensor
A. After the sensor reset to factory settings, the LED(signal light) blinks once per second and
sensor starts searching an enabled Zigbee network.
B. If sensor pairs successfully, it will stop blinking and the light will stay on for 10 seconds
C. If no available networks were found within 2 minutes, the LED will stop blinking and turn
off.
Tip: When initially setting up the ARIZE Water Leak Sensor, it is recommended to perform the setup
task within 15 feet (4.5 meters) of the ARIZE Hub.
4. Once the sensor detects a water leak, the LED Indicator flashes and the alarm beeps once per
second which lasts for 5 minutes, and then beeps 3 times every 10 minutes (with indicator light). The
alarm signal will be sent to the gateway once every 5 minutes. During the alarm status, the user can
mute the buzzer by using the App. If the sensor still detects a water leak after 10 minutes, the detector
will trigger the alarm again and another signal will be sent to the gateway and the user.
The alarm will be canceled if the situation as below.