Installation and Operating Instructions

figure to the down)
MPORTANT NOTE: Operation of this control is dependent on which wire is attached to which terminal.
If operation of control does not correspond to operating buttons on transmitter, reverse wire
installation at the receiver or at the control.
NOTE: Up to 6.3 VDC of power is provided at the receiver terminal.
GENERAL INFORMATION
COMMUNICATION-SAFETY -TRANSMITTER
This remote control has a COMMUNICATION- SAFETY function built into its software. It provides an
extra margin of safety when the TRANSMITTER is out of the normal 20 feet operating range of the
receiver.
The COMMUNICATION-SAFETY feature operates in the following manner, in all OPERATING
MODES-ON/ ON THERMOSTAT.
At all times and in all OPERATING MODES, the transmitter sends an RF signal every fifteen (15) minutes,
to the receiver, indicating that the transmitter is within the normal operating range of 20 feet. Should
the receiver NOT receive a transmitter signal every 15 minutes, the IC software, in the RECEIVER, will
begin a 2-HOUR (120-minute) countdown timing function. If during this 2-hour period the receiver
does not receive a signal from the transmitter, the receiver will shut down the appliance being
controlled by the receiver. The RECEIVER will then emit a series of rapid "beeps" for a period of 10
seconds. Then after 10 seconds of rapid beeping, the RECEIVER will continue to emit a single "beep"
BATTERY BOX AND RECEIVER
SPLIT DIRECTION
RED WIRE
1/4" FEMALE
CONNECTORS
BLACK WIRE
RED WIRE
BLACK WIRE
1/4" FEMALE
CONNECTORS
BLACK WIRE
1/4" MALE
CONNECTORS
RED WIRE
1/4" MALE
CONNECTORS