LCD32FD INSTRUCTION MANUAL BND VOL C MU AM LO T FM MODE RPT STOP BAL AUTO-LOADING COMPACT DISC PLAYER WITH AM/FM TUNING RADIO WWW. LEGACYCARAUDIO.
LOCATION AND FUNCTION OF CONTROLS 1 2 3 4 5 6 7 BND AM MU C RPT MODE 8 VOL LO T FM 9 10 18 11 STOP 13 19 14 12 BAL 15 16 17 1.POWER BUTTON Press it to turn on or off the unit. 2.BAND BUTTON Press it to select your desired radio band AM or FM. 3.CD COMPARTMENT 4.FREQUENCY COUNTER By the pointer, the display shows the frequency of the broadcasting station being received. 5.LED DISPLAY This is to show the track no.of CD. 6.
7. EJECT BUTTON Press it to eject the CD DISC. 8.MUTE BUTTON Press it to reduce the volume level immediately. 9. TUNING KNOB Rotate it to select your desired broadcasting station. 10.LOC BUTTON Press it to select distance reception or local reception. Local control is no effect at AM BAND 11.MODE BUTTON Press it in between CD or radio function. 12. (CD PLAY,PAUSE )BUTTON At tuner mode, press button to switch to CD mode.
15.BALANCE BUTTON Slide it to get you desired sound balance between left channel and right channel. 16,17. TRACK UP/DOWN BUTTONS a. During CD mode, press button to allow you to track forward. Hold the button to allow you to skip forward. b. During CD mode, press button to allow you to track backward. Hold the button to allow you to skip backward. 18.FM LIGHT The frequency in the FM station ,the FM light be lighted. 19.AM LIGHT The frequency in the AM station ,the AM light be lighted.
DISC PLAY: Cleaning discs Before playing ,clean the disc with a clean, lint-free, Flip the disc in the direction of the arrow. Note: Do not use so solvents such as benzine, thinners, commercially available cleaners or anti static spray damage the unit: insert a disc with the label surface down, Doing so may damage the unit. Label surface up Note: Do not try to insert another disc when one has been already inserted. Doing so may damage the unit. Handle the disc by its edge.
TROUBLE SHOOTING Before going through the check list, wiring connection, should any of the problem persist after check list has been made , consult your nearest service dealer. Symptom Cause Solution If the power supply is properly connected to the car accessory switch the ignition key to “ACC” The car ignition is not on.
SPEAKER CONNECTION Speaker connection ANTENNA PLUG WHITE (L) RCA LINE OUT PLUG RED (R) 3A POWER SUPPLY AUTO ANTENNA RED FUSE BLACK GROUND YELLOW L +GREEN -GREEN/WHITE GREY+ R GREY/WHITE- NOTE: In spite of having any kinds of speaker system ,must use 4 ohms impedance of speaker to reduce the distortion during high volume level. SPECIFICATION GENERAL Power requirement------------------------------ DC 13.
INSTALLATION DASH BOARD METAL MOUNTING STRAP HEX NUT SPRING WASHER PLAIN WASHER PLAIN WASHER CONSOLE SLIDE BRACKET HOUSING TAPPING SCREW HEX BOLT KEY PLATE KEY PLATE