User Manual

ASSEMBLY INSTRUCTIONS:
2960-4105/4115/4901 BED
Parts & Hardware List:
Thank you for purchasing this quality product. Before beginning, please check the packing material carefully for
small parts which may have come loose inside the carton during shipping. Please do not discard any packing
material until all parts have been located. If any parts are missing, please contact your dealer for prompt
replacement.
PARTS LIST
Q'TY
B
A
C
D
HEADBOARD
1 PC
RIGHT POST LEG
LEFT POST LEG
1 PC
1 PC
1 PC
BOTTOM STRETCHER
E
FOOTBOARD
1 PC
2 PCS
BED RAIL
F
G
H
SLAT
SUPPORT LEG
3 PCS
3 PCS
PARTS LIST
Q'TY
HARDWARE LIST
1
Q'TY
SHORT BOLT
2
SPRING WASHER
3
WRENCH
4
5/16"*1-3/8"
5/16"
87*12mm
2 PCS
16 PCS
8 PCS
LONG BOLT
5/16"*1"
8 PCS
5/16"*19*2mm
FLAT WASHER
WOOD DOWEL
10*40mm
4 PCS
6
7
8 PCS
HARDWARE LIST
Q'TY
Assembly Procedures:
Step 1: Lay out all parts and hardware. Make sure the quantity of each is correct and the feet are free of stain,
staples, screws and nails.
Step 2: Assemble the right & left support legs (C&D) to stretcher (B) as shown.
Assemble the right & left support legs (C&D) to headboard (A) as shown.
Step 3: Assemble the bed rails (F) to headboard outer holes (A) and footboard (E) as shown.
Step 4: Assemble the support legs (H) to the slats (G), then assemble the slats to the bed rails as shown.
8 PCS
5
8
8*1-1/4"
6 PCS
WOOD SCREW
5/16"*16*1.2mm
FLAT WASHER
1
2
4
3
Step 2
1
2
4
3
5
2
4
7
8
G
G
H
A
E
F
F
A
B
C
D
C
D
Caution: Over-tighting screws or bolts may result in damage. It is suggested that at least two people work together
for this assembly process to avoid injury. Following assembly, the furniture should be cleaned with a quality,
non-silicone furniture polish on a clean, soft cloth.
www.legacyclassickids.com