Instructions / Assembly

OPERATION INSTRUCTIONS

DANGER

• CARBON MONOXIDE HAZARD

• For outdoor use only. Never use inside house, or other

unventilated or enclosed areas. This heater consumes air

(oxygen). Do not use in unventilated or enclosed areas to

avoid endangering your life.

Before Turning Gas Supply ON:

1. Your heater was designed and approved for outdoor use only. Do NOT use it inside a building,

garage, or any other enclosed area.

2. Make sure surrounding areas are free of combustible materials, gasoline, and other flammable

vapors or liquids.

3. Ensure that there is no obstruction to air ventilation. Be sure all gas connections are tight and

there are no leaks.

4. Be sure the cylinder cover is clear of debris. Be sure any component removed during assembly or

servicing is replaced and fastened prior to starting.

Before Lighting:

1. Heater should be thoroughly inspected before each use, and by a qualified service person at least

annually. If relighting a hot heater, always wait at least 5 minutes.

2. Inspect the hose assembly for evidence of excessive abrasion, cuts, or wear. Suspected areas

should be leak tested. If the hose leaks, it must be replaced prior to operation. Only use the

replacement hose assembly specified by manufacturer.

LIGHTING INSTRUCTIONS

Check and ensure that an AA battery is inside the

ignition chamber and has power.

Ensure the

anode(+) faces outside.

Caution: Do not attempt to operate until you have read and understand all General Safety Information

in this manual and all assembly is complete and leak checks have been performed.

1.Ensure that the control knob is OFF. Slowly open the gas cylinder valve.

2.Press and turn the control knob to LIGHT position, push the igniter to generate spark while

keeping control knob in pressed position