Instructions / Assembly

9
ASSEMBLY INSTRUCTIONS
7
8
7. Carefully install the glass tube (E) by lifting
up and inserting through the center hole in
the upper plate. Ensure the rubber ring(GG)
is attached to the lower edge of the glass tube
as illustrated. Slide the glass tube through the
hole of the lower plate cover and onto the
middle plate. Check and ensure that
the glass tube is positioned properly and is
completely covering the center hole of the
middle plate.
8. Attach the wire guards(D) ont
o the heater
by inserting the hooks into the holes on the
frame, (ensure that all of the hooks engage).
Unscrew 4pcs screws from damper
Using the (M3/16) screws secure the guards
in place by fastening the fixing brackets (BB)
to the top of the upper plate and over top of
the guards as illustrated. Repeat this
procedure until all guards are installed.
WARNING! The rubber
ring must be in place
prior to operating the heater.
To aid in installation
place rubber
ring(GG) on the
middle plate and
then install glass tube.
Ensure the rim of
the glass tube sits
firmly in the rubber
ring.
GG
D
E
BB