Instructions / Assembly

11
Leak Test
1. Make 2-3 oz. of leak test solution (one part liquid dishwashing detergent and three parts water).
2.Apply several drops of solution where hose attaches to regulator.
3.Apply several drops of solution where regulator connects to cylinder.
4. Make sure all fire pit and light valves are OFF.
5.Turn cylinder valve ON.
If bubbles appear at any connection, there is a leak.
1. Turn cylinder valve OFF.
2. If leak is at hose/regulator connection: ti
ghte
n connection and perform another leak test. If bubbles continue appearing,
the hose should be returned to the place of purchase.
3. If leak is at regulator/cylinder valve connection: disconnect, reconnect, and perform another leak test. If you continue to
see bubbles after several attempts, cylinder valve is defective and should be returned to cylinder place of purchase.
If NO bubbles appear at any connection, the connections are secure.
NOTE: Whenever gas connections are loo
sene
d or removed, you must perform a complete leak test.
Complete installation.
OPERATION INSTRUCTIONS
WARNING
Perform all tests outdoors.
Extinguish all open flames.
NEVER leak test when smoking.
Do not use the fire pit until all connections have
been leak tested and do not leak.
Hose/Regulator Regulator/Cylinder
Connection Connection