Instructions / Assembly

13
WARNING
FOR YOUR SAFETY
Be careful when attempting to manually ignite this fire pit.
Holding in the control knob for more than 10 seconds
before igniting the gas will cause a ball of flame upon
ignition.
Re-lighting:
1. Turn control knob to OFF.
2. Repeat the "Lighting” steps on prior page.
WARNING
FOR YOUR SAFETY
Fire pit will be hot after use. Handle with extreme care.
Shut Down:
1. To extinguish burner depress control knob and continue to turn it clockwise to OFF.
2. Turn cylinder valve clockwise to OFF and disconnect regulator when fire pit is not in use.
WARNING
FOR YOUR SAFETY
Do not touch or move fire pit for at least 45 minutes after
use.
Fire pit is hot to the touch.
Allow fire pit to cool before touching.
To enjoy years of outstanding performance from your fire pit, make sure you perform the following maintenance activities
on a regular basis:
Keep exterior surfaces clean.
1. Use warm soapy water for cleaning. Never use flammable or corrosive cleaning agents.
2. While cleaning your unit, be sure to keep the area around the burner dry at all times. Do not submerge the control valve
assembly. If the gas control is submerged in water, do NOT use it. It must be replaced.
a. Keep the applian
ce area
clear and free from combustible materials, gasoline and other flammable vapors and liquids.
b. Do not obstruct the flow of combustion and ventilation air.
c. Keep the ventilation opening of the cylinder enclosure free and clear from debris.
3. Air flow must be unobstructed. Keep controls, burner, and circulating air passageways clean. Signs of possible
blockage include:
OPERATION INSTRUCTIONS
CARE AND MAINTENANCE