Product Brochure

7776
INSTALLATION GUIDELINESINSTALLATION GUIDELINES
4
Connect new switch as shown.
Make sure the terminal holes are
clear. Insert wires into terminals
and tighten screws securely.
NOTE - If you are installing mul-
tiple switches in the frame, wire
all devices before snapping them
into the frame.
Single Pole
• Connect one wire to 1-POLE.
• Connect other wire to HOT.
• Do NOT use 3-WAY.
3-Way
• Connect the wire identified as
Common/Hot in Step 1 to HOT.
• Connect one of the other wires
to 1-POLE.
• Connect remaining wire to 3-WAY.
NOTE - If you have purchased an
adorne
®
Locator Light or Accent
Nightlight, please refer to those
instructions at this step.
WARNING: Do not pair different size wires in the same
terminal. If you have different size wires, use a wire nut to add a
6 inch pigtail of the same gauge wire to the smaller gauge wire.
Same size. Different size.Different size with pigtail.
NOTE – If you need to remove
switch after snapping into frame,
first remove frame from wall box
to access the three locking tabs
on the back of the switch. Insert
a flat screwdriver to depress tabs
as you apply pressure to push
switch out.
NOTE – To remove wall plate,
insert a small, flat screwdriver in
notches on wall plate and twist
gently to pry from frame.
5
Carefully fold wires into box.
Snap switch into frame.
6
Snap wall plate to frame.
There are three click-stops to
adjust the fit of the wall plate to
the switch and the wall.
1
2
3
Never apply cleaner directly to the
switch or wall plate. Apply to a soft
cloth and use cloth to remove any
smudges from the product.
Sample Installation: Paddle Switch, 2-Module | Continued