Specification Sheet

56
12” Modular Track Includes one Tamper-Resistant Outlet Module and one Blank Module.
Can support up
to two LED lights.
Provides 120V power via 15A outlet modules and 20A pass-through.
Module openings are 6” on-center.
APMT12TM2
APMT12W2
18” Modular Track Includes one Tamper-Resistant Outlet Module and one Blank Module.
Can support up to two LED lights.
Provides 120V power via 15A outlet modules and 20A pass-through.
Module openings are 9” on-center.
APMT18TM4
APMT18W4
27” Modular Track Includes two Tamper-Resistant Outlet Modules and one Blank Module.
Can support up to three LED lights.
Provides 120V power via 15A outlet modules and 20A pass-through.
Module openings are 9” on-center.
APMT27TM2
APMT27W2
18” Modular Track Extender Enables a perfect fit for any kitchen. Simply cut to length (minimum of
6”) and attach to end of Modular Track.
Does not include any module openings.
APME18TM2
APME18W2
Modular Track Corner Connector Use with installations that include a right-angle corner to connect two
Modular Tracks.
Allow 3” on each side for installations with Corner Connectors.
APCCTM4
APCCW4
Short Modular Track Includes one Tamper-Resistant Outlet Module. Intended for use on short
cabinet sections. 10” in length but can be cut to 8”.
Enables direct wire connection to wiring behind the wall.
Cannot be combined with any other track section.
APST9TM1
APST9W1
Pro Kit Includes the adorne control box with the paddle dimmer, 18” Track, 12”
Track, an additional tamper-resistant outlet, and a tablet cradle.
APMTPROTM1
Modular Tracks
The adorne system is a flexible and modular solution designed to eliminate kitchen clutter.
Fully customizable, you can select from several types of modules and modify your system
in minutes. Simply pop out an existing module and replace it with a new module at any time.
The Modular Tracks listed below simply plug together to create a full system custom-
designed for any kitchen. They form the base of the system, housing all of the wiring
that connects the modules.
Each system must include a Control Box or Direct Wire Connector that is hardwired to
existing wiring or plugged into an outlet on the backsplash.
NAME COMPLIANCE SPECIFICATIONS PART NUMBER
56
UNDER-CABINET LIGHTING & POWER SYSTEM