Wireless Video User Guide

Page 22
301 Fulling Mill Road, Suite G ©Copyright 2013 by Legrand,
Middletown, PA 17057 Inc All Rights Reserved.
(800)-321-2343 www.onqlegrand.com
If you did create a new Master Unit,
you should see this screen.
Note that there is a little house icon
on the same line as this unit’s
default name (Room 1).
NOTE: When Tech Support
directed you to “Unpair” or
“System Reset” all the units, they
should have also had you unpair
or reset the Door Unit by holding
its doorbell button for @10
seconds (until it beeps at you)
and like unpaired or system reset
Room Units, begins beeping
twice every few seconds.
They should have also had you
unplug each Room Unit after it
was reset.
You can only pair one unit at a time,
so generally, on a new or
completely reset system, after all
the units are reset and unplugged, it
is a good idea to first plug in the
Door Unit and from the Master
Room Unit perform steps E1 above
to first add the Door Unit.
After you’ve added the Door Unit,
the screen should look like this.
To add any additional Room Units,
again perform the steps in section
E1 above (ie. Apply power to new
Room Unit and from Master Room
Unit “Add Paired Unit”).