Specification Sheet

8584
4
Connect new outlet as shown.
Make sure the terminal holes
are clear. Insert wires into
terminals and tighten screws
securely.
NOTE - If you are installing
multiple outlets in the frame, wire
all devices before snapping them
into the frame.
5
Carefully fold wires into box.
Snap outlet into frame.
NOTE – If you need to remove outlet after snapping into frame, first
remove frame from wall box to access the three locking tabs on the
back of the outlet. Insert a flat screwdriver to depress tabs as you
apply pressure to push outlet out.
6
NOTE – To remove wall plate, insert a small,
flat screwdriver in notches on wall plate and
twist gently to pry from frame.
HOTHOT
STRIP GAGE
#14-#12 AWG
WHITE
HOTHOT
STRIP GAGE
#14-#12 AWG
WHITE
If you have four wires plus a ground wire If you have two wires plus a ground wire
HOTHOT
STRIP GAGE
#14-#12 AWG
WHITE
HOTHOT
STRIP GAGE
#14-#12 AWG
WHITE
1
2
3
Snap wall plate to frame.
There are three click-stops to adjust the fit
of the wall plate to the outlet and the wall.
Never apply cleaner directly to the outlet or
wall plate. Apply to a soft cloth and use cloth to
remove any smudges from the product.
WARNING: Do not pair different size wires in the same
terminal. If you have different size wires, use a wire nut to add a
6 inch pigtail of the same gauge wire to the smaller gauge wire.
Same size. Different size.Different size with pigtail.
INSTALLATION GUIDELINESINSTALLATION GUIDELINES
Sample Installation: Tamper-Resistant Outlet | Continued