Specification Sheet

adorneTM GUIDE SPECIFICATIONS
Project Name Project No. Date
Project Location 16140-2 Wiring Devices
1. UL 20 - Standard for General-Use Snap Switches.
2. UL 498 - Standard for Attachment Plugs and Receptacles.
3. UL 508 - Standard for Industrial Control Equipment.
4. UL 514D - Standard for Cover Plates for Flush-Mounting Devices.
5. UL 1310 - Standard for Class 2 Power Units.
6. UL 1472 - Standard for Solid-State Dimming Controls.
7. UL 1786 - Standard for Direct Plug-in Nightlights.
8. UL 1917 - Standard for Solid-State Fan Speed Control.
1.5 SUBMITTALS
Specifier Note: In this article, specify various types of data to be furnished by the contractor be-
fore, during, or after construction. Topics included in this article are: product data, shop draw-
ings, samples, design data, test reports, certificates, manufacturers’ instructions, manufacturers’
field reports, qualification statements, and closeout submittals.
A. Submit under provisions of Section [01330] [______].
B. Product Data: Submit for each type of product specified.
1.6 QUALITY ASSURANCE
Specifier Note: In this article, describe qualifications, regulatory requirements, certifications, field
samples, mock-ups, and pre-installation meetings.
A. Manufacturer Qualifications: Firms regularly engaged in manufacture of devices and
wall plates of the types and sizes required, whose products have been in satisfactory
use in similar service for not less than 10 years. Provide fire classified electrical floor
boxes and fittings produced by a manufacturer listed in this section.
B. Source Limitations: Obtain each type of device and wall plate through one (1) source
from a single manufacturer.
C. Wiring Devices, Components, and Accessories: CULus listed and labeled and/or
CETLus Listed and labeled as defined in NFPA 70, to have been tested and met the
minimum requirements of the prescribed NEMA and UL product safety standards.
Marked for intended location and application.
1.7 DELIVERY, STORAGE AND HANDLING
A. Deliver wiring devices and wall plates in factory labeled packages.
B. Store and handle in strict compliance with manufacturer’s written instructions and
recommendations.
C. Protect from damage due to weather, excessive temperature, and construction
operations.
PART 2 - PRODUCTS
2.1 MANUFACTURERS
A. Basis-of-Design Product: The design for wiring devices and wall plates is based on
products manufactured by legrand
®
/adorne
™
, 60 Woodlawn Street, West Hartford, CT
06110; toll-free 877-295-3472, telephone [phone], Web Site:
www.legrand.us/adorne.
B. Substitutions will be considered under provisions of Section 01635.
2.2 OUTLETS