radiant® Tru-Universal SETUP QUICKSTART GUIDE HOW TO: - Run Autocalibration - Change to Reverse Phase - Adjust High End Trim - Adjust Low End Trim - Disable Autocal - Set to MLV Mode
AUTOCALIBRATION TO RUN AUTO CALIBRATION FEATURE ON DIMMER: Press Calibration Button TOP OF DIMMER INDICATOR LED Dimmer will Auto Configure (will flash to indicate changes) Dimmer is now Calibrated FORWARD/REVERSE PHASE SWITCH (F/R) REVERSE PHASE TO CHANGE TO REVERSE PHASE: Set F/R Switch to R* Press and Release Calibration Button CALIBRATION BUTTON (CAL) (Push button that can be invoked with a pen or small screwdriver) Dimmer will Auto Configure Dimmer is now Calibrated *To switch back to forward p
LOW END TRIM TO ADJUST LOW END TRIM: Move Slider Down to MIN Press and Hold CAL for ~ 5 Seconds TOP OF DIMMER LED will Blink, Release CAL INDICATOR LED (will flash to indicate changes) Adjustment Saved Move Slider Up when at Desired Setting Push CAL 12x to Cycle through Adjustments* FORWARD/REVERSE PHASE SWITCH (F/R) *Some LED’s should not be set at their lowest setting. While they may be able to dim to that level after being on, they may not turn on to that level.
DISABLE AUTOCAL TO DISABLE AUTOCAL AT POWER UP: Press and Hold CAL for ~ 5 Seconds Move Slider Down to MIN LED will STOP Blinking Press and Hold CAL for ~10 Seconds at Desired Setting** LED will Blink, Release CAL INDICATOR LED * See low end trim. ** Low end trim adjustments must be made before disabling autocal, at least one adjustment needs to be made.