Legrand Wireless Lighting Installation in existing three-way circuits WARNING: PLEASE READ THIS ENTIRE GUIDE BEFORE BEGINNING INSTALLATION OF YOUR RF LIGHTING OR REMOVAL OF YOUR OLD SWITCH. INCORRECT INSTALLATION CAN CAUSE SERIOUS INJURY AND POTENTIAL DAMAGE TO YOUR RF LIGHTING SYSTEM OR YOUR HOME.
Before you Start Review this guide in its entirety before beginning device installation. Please be advised that nothing found in this guide can anticipate your situation or has been reviewed by people with the expertise required or knowledge of your specific project, environment, electronics, electrical products or equipment to provide you with complete, accurate or reliable information. This guide does not constitute, guarantee or provide, expressly or implicitly, nor does it replace, professional advice.
What you Need REQUIRED: • Phillips-head screwdriver • Flat blade screwdriver • Non-contact voltage tester YOU MAY ALSO NEED: • Pliers, wire cutter, wire stripper, electrical tape, flashlight, wiring leads (included), and wire nuts (included) • NOTE: Do NOT use a power screwdriver or other power tool to install the device as it may lead to over-tightening. Over-tightening screws can damage the device and cause a mechanical malfunction.
Step 1 Prepare existing devices. ! Step 3 Determine which circuits are connected by identifying the wires in each box. Use the diagrams below as a guide. Once you have determined the wiring type that you have, follow the steps that correspond with that Circuit Type (A, B, or C). If you are unsure, stop immediately and contact a licensed electrician for assistance. Identify the existing wiring. Switch power off at the panel. Remove both switch plates. Pull devices from their boxes.
Type A Step A1 Step A2 Locate the HOT and LOAD sides of the circuit. Connect your new switches or dimmers. ! Switch power ON at the panel. Use a non-contact voltage tester to locate and LABEL the HOT wire. Make sure to check both switch locations. (Follow the instructions provided with the tester.) ! Switch power OFF at the panel. Wire your new Legrand devices per the diagram below by first connecting Remote to the supply side using the instructions included.
! Type B White ! ! White ! ! Load Breaker Panel Hot Locate the HOT and LOAD sides of the circuit. ! Step B2 Step B3 Wire your new Legrand devices per the diagram below by first connecting Remote to the supply side using the included instructions. Install wall plates. Connect your new switches or dimmers. Ensure power is OFF at the panel. Locate the box with both a 2-wire and a 3-wire. This is the SUPPLY side of the circuit.
Type C Step C1 Locate the HOT and LOAD sides of the circuit. ! Ensure power is OFF at the panel. Locate the box with both a 2-wire and a 3-wire. This is the LEG side of the circuit. Step C2 Step C3 Wire your new Legrand devices per the diagram below by first connecting Remote to the supply side using the included instructions. Install wall plates. Connect your new switches or dimmers. Next, connect Master to the LOAD side using the included instructions. The remaining box is the LOAD side.
From the world leader in electrical switches and outlets http://www.legrand.us/3wayinstallationinstructions FOLLOW US designed to be better™ Legrand, North America 60 Woodlawn Street West Hartford, CT 06110 1.877.BY.LEGRAND (295.3472) www.legrand.us 570 Applewood Crescent Vaughan, Ontario L4K 4B4 905.738.9195 www.legrand.ca ©2018 by Legrand. All Rights Reserved.
