Installation Guide

10
installation & setup
step three
|
wire the smart dimmer
Use the wire nuts provided to secure the wires together.
1
Connect the WHITE neutral wire on the dimmer to the neutral wires in the box,
using the red wire nut.
2
Connect the LOAD wire on the dimmer to the load wire in the box.
3
Connect the HOT wire on the dimmer to the hot wire(s) in the box.
4
Connect the GREEN ground wire on the dimmer to the ground wire(s) in the box.
5
If the light is controlled with only one switch, use a wire nut to cap the YELLOW
traveler wire on the device.
NOTE: These instructions are for installations where only one switch is replaced. If you have
multiple dimming locations, use the radiant HMR multi-location dimming remotes.
Use the yellow traveler wire for that application.