User's Manual

FCC Requirement
Any changes or modifications not expressly approved by the party responsible for compliance could
void the user
’
s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause
undesired operation.
Note: This equipm ent has been tested and found to comply with the limits .pursuant to Part 15 of
the FCC Rules. These limits are designed to provide reasonable protectionagainst harmful
interference in a residential installation. This equipment generates, uses, and canradiate radio
frequency energy, and if not installed and used in accordance with the instructions,may cause
harmful in terference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipm ent does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipm ent into an outlet on a circuit different from that to which the receiver is
connected.
– Consult the dealer or an experienced radio/TV technician for help.
RF exposure considerations This modular complies with FCC RF radiation exposure limits set forth
for an uncontrolled environment. This transm itter must not be co-located or operating in
conjunction with any other antenna or transmitter.
RF Exposure - This device is only authorized for use in a mobile application. At least 20 cm of
separation distance between the module and the user's body must be maintained at all times.
A label must be affixed to the outside of final commercial product with the following statements:
This device contains FCC ID:2AWSF-M BP00
Consistent with §2.909(a), the following text must be included within the user’ s manual or operator
instruction guide for the final commercial product.
This modular complies with FCC RF radiation exposure limits set forth for an uncontrolled
environment. This transm itter must not be co-located or operating in conjunction with any other
antenna or transmitter.