Owners Manual

Technical details
The passive filter network of the Black Cube SE II is located between two linear active amplifier
stages. Phase errors that occur due to active filter designs are thereby eliminated. Low-loss,
high precision WIMA MKP capacitors in the filter network and cor output coupling are responsible for very good localization
and soundstage reproduction.
There is a hard wire Slot for switch free addition of extra custom impedance. This means there is no need for expensive
impedance plugs!
The low output impedance can drive long cable runs and the external regulated PWX power supply of the Black Cube SE II can
be placed up to two meters away from the audio section. The cable between power supply and audio section is shielded to
keep Radio Frequency Interference (RFI) away from the nearly noiseless and highly stable supply voltages. This effect is even
enhanced by additional supply voltage filtering on the double-sided audio pcb.
A case of 2mm aluminum protects the audio electronics.
Made in Germany
Please read this manual first before connecting the Black Cube SE II to mains voltage!