Owners Manual

Rear side (Connectors)
1. Ground connector
If your turntable has a separate ground connection you can connect it here.
- wire, open cable ends
- cable shoes
- 4mm banana plug
2. Input for the external PWX power supply.
The external PWX power supply is connected through a 2m shielded cable with an original Neutrik 4-pin XLR connector on one
end. The PWX power supply will give much more authority, authenticity, liveliness, pace and timing to your turntable’s music
reproduction than the standard Black Cube power supply. There will be a deeper black in the background and a more
holographic soundstage.
3. Output Left Channel
4. Input Left Channel
5. Output Right Channel
6. Input Right Channel
The outputs (3; 5) are RIAA-equalized line level outputs to connect either e line input of a preamp ore directly to a power amp
with volume control. Please take care for the correct channel polarity.
Please do not connect the outputs of the Black Cube SE II to a phono input of your amplifier. The RIAA filtering and the
gain would be applied twice to the signal. Extremely loud signals could damage your loudspeakers or even your
hearing.