Owners Manual

Lehmannaudio Manual Decade - page 6 -
Rear side audio section: (simplified)
6
1 2 3 4 5
1. S ignal input connector (In) Left Channel
2. Signal output connector (OUT) Left Channel
3. Input for the external PWX II power supply
Please connect the power supply to the audio section first and then connect the complete unit to mains voltage!
4. S ignal output connector (OUT) Right Channel
5. Signal input connector (In) Right Channel
6. Ground connection
If your turntable has a separate ground cable you should connect it here. You can connect any of 4mm plugs, open ends, or
cable shoes
The signal output connectors are supplying RIAA-filtered high-level output signals. Please connect your output cables to the
line input to be used. For example, to a line-level preamplifier, active loudspeakers with volume control or power amplifier
input with volume control.
Be careful to preserve correct channel connections – left to left and right to right.
W A R N I N G: You must not connect the output cables to a following phono input because RIAA-filtering and amplification
would be done twice! You could damage the following phono stage or your power amplifier and loudspeakers! The resulting
noise could even damage your hearing!!!