User guide

Leica EG 1160 – Paraffin Embedding Center 19
ACT Mode (Operation)
5.4 The paraffin flow rate is selectable in 10% incre-
ments:
10 %, 20 %, 30 %, 40 %, 50 %, 60 %, 70 %, 80 %,
90 %, 100 %
The display reading will change with the selected
flow rate. It always reads the percentage flow rate
selected.
Increase/decrease
of the flow rate
How to quit the display reading "FLOW RATE":
1. Approximately 10 seconds after having selected the
flow rate, the display will automatically return to the
ACT default reading.
2. Pushing the MENU button will also lead to the ACT
default reading.
3. Pushing the SET/ACT button will lead to the pro-
gramming mode (SET mode).
Note: If a flow rate of 10% is selected, the SET/ACT
button will lead to the programming mode "ADJUST
FLOW RATE" (see 5.3).
5.5 SWITCHING OFF with the ON/OFF button
By pushing the ON/OFF button, the instrument au-
tomatically returns to the standby condition.
It is not necessary to switch the tissue embedding
center off with the main switch. If switched off with
the main switch, all programmed parameters are
maintained. In this case, however, the program will
not be activated.
In the SET mode, the ON/OFF button has an addi-
tional function for the programming of temp–
eratures and workdays (see 6.1, 6.4).
10. Operation
PAR-TANK +XX°C
DI 13:15
PAR-TANK +XX°C
DI 13:15
TEMPERATURWAHL
DI 13:15
10 sec
10 sec
FLOW RATE 80%
TU 13:15
FLOW RATE 80 %
TU 13:15
FLOW RATE 80 %
TU 13:15
FLOW RATE 80%
TU 13:15
PAR TANK +XX°C
TU 13:15
TU 13:15