Manual

31
Leica TP1020
4. Instrument Setup
Fig. 14
5
4
2
4.3.2 Adjusting the voltage selector
• Insertthesmallscrewdriver(4) into the smaller
one of the two notches at the lower end of the
lock (5) using the screwdriver as a lever.
• Removetheshell(3).
• Removethevoltageselector(6) from the shell
(3) and reinsert it so that the correct voltage
selection can be seen in the window (1) of the
shell.
• Insertthevoltageselectorshell(3) together
with the voltage selector (6) and fuses (7) back
into the receptacle in the instrument and press
lightly until it locks.
• Checkagainiftherightsettingshowsinthe
window (1).
Fig. 15
1
6
7
3
When adjusting the voltage selector
setting, the instrument must be discon-
nected from the mains.