User's Manual
Table Of Contents
- 1 Safety Directions
- 2 Description of the System
- 3 User Interface
- 4 Operation
- 4.1 Equipment Setup
- 4.1.1 Setting up as a Post-Processing Base
- 4.1.2 Fixing the Field Controller to a Holder and Pole
- 4.1.3 Fixing a Hand Strap to the CS
- 4.1.4 Fixing the Utility Hook to the CS
- 4.1.5 Replacing the Display Foil on the CS
- 4.1.6 Inserting and Removing a SIM Card
- 4.1.7 Setting Up for Remote Control or RTK using an Expansion Pack
- 4.1.8 Connecting to a Personal Computer
- 4.1.9 Enabling WLAN in Windows EC7
- 4.2 Batteries
- 4.3 Power Functions
- 4.4 Working with the Memory Device
- 4.5 Using the Digital Camera
- 4.6 Using the Camera Flash Light as Torch
- 4.1 Equipment Setup
- 5 Care and Transport
- 6 Technical Data
- 7 Software Licence Agreement
- Appendix A Pin Assignments and Sockets
4 Operation
4.1 Equipment Setup
4.1.1 Setting up as a Post-Processing Base
The equipment setup described is used for static operations over markers.
The instrument can be programmed with the field controller before use which
can then b
e omitted from the setup.
•
T
he antenna is mounted directly using screw fitting. If using stub and
adapter, procedures can vary slightly.
•
When using the adapter and carrier, ensure that the antenna and the
adapter assembly slide down the full length of the carrier stub. An incor-
rectly mounted antenna will have a direct effect on the results.
If the instrument is left in the container during use in high temperatures, the
lid should b
e left open. Refer to the User Manual for operating and storage
temperatures.
Use an external battery such as GEB371 to ensure operation for a full day.
002496_003
a
b
c
i
d
e
f
g
h
j
b
k
l
Use
Description
☞
☞
☞
Equipment setup
32 Operation