User's Manual
Table Of Contents
- 1 Safety Directions
- 2 Description of the System
- 3 User Interface
- 4 Operation
- 4.1 Equipment Setup
- 4.1.1 Setting up as a Post-Processing Base
- 4.1.2 Fixing the Field Controller to a Holder and Pole
- 4.1.3 Fixing a Hand Strap to the CS
- 4.1.4 Fixing the Utility Hook to the CS
- 4.1.5 Replacing the Display Foil on the CS
- 4.1.6 Inserting and Removing a SIM Card
- 4.1.7 Setting Up for Remote Control or RTK using an Expansion Pack
- 4.1.8 Connecting to a Personal Computer
- 4.1.9 Enabling WLAN in Windows EC7
- 4.2 Batteries
- 4.3 Power Functions
- 4.4 Working with the Memory Device
- 4.5 Using the Digital Camera
- 4.6 Using the Camera Flash Light as Torch
- 4.1 Equipment Setup
- 5 Care and Transport
- 6 Technical Data
- 7 Software Licence Agreement
- Appendix A Pin Assignments and Sockets
a GS instrument
b
(micro)SD card
c GEB212 battery
d GRT146 carrier
e Tribrach
f Height hook
g Tripod
h Utility hook
i CS20 field controller
j GEB331 battery
k CS35 tablet
l USB stick
1. Set up the tripod.
2. Mount and level the tribrach on the tripod.
3. Ensure that the tribrach is over the marker.
4. Place and lock the carrier in the tribrach.
5. Insert the data storage device and the batteries into the GS.
6. Screw the GS onto the carrier.
7. Check that the tribrach is still level.
8. Insert the data storage device and the battery into the field control-
ler
.
9. Switch on the field controller and connect it to the instrument if nec-
essary.
10. To hang the field controller on the tripod leg, use the hook on the
hand strap or use the utility hook. Refer to the User Manual of the
field controller.
11. Insert the height hook into the carrier.
12. Measure the antenna height using the height hook.
13. Press the ON/OFF button on the instrument for at least 2 s to switch
on the instrument.
4.1.2 Fixing the Field Controller to a Holder and Pole
The GHT66 holder consists of the following components:
008545_001
a
b
c
f
d
e
g
h
i
GHT63 clamp
a Plastic sleeve
b
Pole clamp
c Clamp bolt
GHT66 holder
d Locking pin
e Top clip
f Mounting plate
g Bottom clip
h Tightening screw
i Mounting arm
Equipment setup
s
tep-by-step
Components of the
GHT66 holder
Operation 33