User's Manual
Table Of Contents
- 1 Safety Directions
- 2 Description of the System
- 3 User Interface
- 4 Operation
- 4.1 Equipment Setup
- 4.1.1 Setting up as a Post-Processing Base
- 4.1.2 Fixing the Field Controller to a Holder and Pole
- 4.1.3 Fixing a Hand Strap to the CS
- 4.1.4 Fixing the Utility Hook to the CS
- 4.1.5 Replacing the Display Foil on the CS
- 4.1.6 Inserting and Removing a SIM Card
- 4.1.7 Setting Up for Remote Control or RTK using an Expansion Pack
- 4.1.8 Connecting to a Personal Computer
- 4.1.9 Enabling WLAN in Windows EC7
- 4.2 Batteries
- 4.3 Power Functions
- 4.4 Working with the Memory Device
- 4.5 Using the Digital Camera
- 4.6 Using the Camera Flash Light as Torch
- 4.1 Equipment Setup
- 5 Care and Transport
- 6 Technical Data
- 7 Software Licence Agreement
- Appendix A Pin Assignments and Sockets
4.1.6 Inserting and Removing a SIM Card
2b
3
4
8
9a
2a
9b
5s = OFF
1
7b
7a
6a
6b
5b
5a
8506_002
☞
Inserting/removing the SIM card while the CS20 is turned on can
result in permanent damage to the card. Only insert/remove the SIM
card when the CS20 is switched off.
☞
The SIM card is inserted into a slot inside the battery compartment.
1. Switch off the field controller.
2. Push the slide fastener of the battery compartment in the direction
of the arrow with the open-lock symbol.
Remove the cover from the battery compartment.
3. Remove the battery from the battery compartment.
4. Bend up the flap that covers the SIM card holder.
5. Push the SIM card holder in the direction of the OPEN arrow and flip
it up.
6. Place the SIM card into the SIM card holder, the chip facing the con-
nectors inside the slot - as shown beside the SIM card holder.
7. Press the SIM card holder down and push the SIM card holder in the
direction of the LOCK arrow to close.
8. Bend down the flap again and reinsert the battery.
9. Attach the cover of the battery compartment. Push the slide fastener
of the battery compartment in the direction of the arrow with the
closed-lock symbol.
4.1.7 Setting Up for Remote Control or RTK using an Expansion Pack
This section does only apply to the CS20 LTE (DISTO) models.
☞
The CTR20 is no
t available in EU countries.
Insert and remove a
SI
M card step-by-step
Attaching the exten-
sion pa
ck step-by-
step
Operation 37