User's Manual
Table Of Contents
- 1 Safety Directions
- 2 Description of the System
- 3 User Interface
- 4 Operation
- 4.1 Equipment Setup
- 4.1.1 Setting up as a Post-Processing Base
- 4.1.2 Fixing the Field Controller to a Holder and Pole
- 4.1.3 Fixing a Hand Strap to the CS
- 4.1.4 Fixing the Utility Hook to the CS
- 4.1.5 Replacing the Display Foil on the CS
- 4.1.6 Inserting and Removing a SIM Card
- 4.1.7 Setting Up for Remote Control or RTK using an Expansion Pack
- 4.1.8 Connecting to a Personal Computer
- 4.1.9 Enabling WLAN in Windows EC7
- 4.2 Batteries
- 4.3 Power Functions
- 4.4 Working with the Memory Device
- 4.5 Using the Digital Camera
- 4.6 Using the Camera Flash Light as Torch
- 4.1 Equipment Setup
- 5 Care and Transport
- 6 Technical Data
- 7 Software Licence Agreement
- Appendix A Pin Assignments and Sockets
Appendix A Pin Assignments and Sockets
A.1 CS20
Some applications require knowledge of the pin assignments for the instru-
men
t ports.
In this chapter, the pin assignments and sockets for the instrument ports are
explained.
008379_001
ab
a LEMO port (USB and serial)
b USB A Host port
1
7
6
8
5
4
3
2
PIN_001
Pin Signal
Name
Function Direction
1 USB_D+ USB data line In or out
2 USB_D- USB data line In or out
3 GND Signal ground -
4 RxD RS232, receive data In
5 TxD RS232, transmit data Out
6 ID Identification pin In or out
7 PWR Power input, 10.5 V-18 V In
8 GPIO RS232, general purpose signal In or out
A.2 GS07
Some applications require knowledge of the pin assignments for the instru-
ment ports.
In this chapter, the pin assignments and sockets for the instrument ports are
explained.
Description
Ports at the instru-
m
ent bottom panel -
LEMO connector
Pin assignments for
8 pin LE
MO-1
Description
60 Pin Assignments and Sockets