User Manual

CS20, Operation

Connect USB cable

to PC for the first

time step-by-step

Step Description

1. Start the PC.

2. Plug the GEV234 cable into the field controller.

3. Turn on the field controller.

4. Plug the GEV234 cable into the USB port of the PC. The Found New Hard-

ware Wizard starts up automatically.

5. Check Yes, this time only. Next>.

6. Check Install the software automatically (Recommended). Next>. The

software for Remote NDIS based LGS CS Device will be installed on your

PC.

7. Finish.

8. The Found New Hardware Wizard starts up automatically a second time.

9. Check Yes, this time only. Next>.

10. Check Install the software automatically (Recommended). Next>. The

software for LGS CS USB Device will be installed on your PC.

11. Finish.

008508_001