User Manual
Table Of Contents
- Introduction
- Table of Contents
- 1 Unpacking the Container
- 2 Using the iCON gps 60 SmartAntenna
- 3 Leica iCON gps 60 User Interface
- 4 Software Tools
- 5 Setups with Controller and Accessories
- 6 Care and Transport
- 7 Safety Directions
- 8 Technical Data
- 9 International Limited Warranty, Software Licence Agreement
- Index
iCON gps 60, Software Tools 57
2. Choose correct SmartAntenna mode:
• If iCON gps 60 is in base mode:
– BasePilot starts up automatically.
• If iCON gps 60 is in rover mode:
–Go to Settings\Tools\Base Setup and choose Find Nearest and
confirm selection with key (refer also to "Function: Find
Nearest step-by-step").
3.
While BasePilot is setting up: The position icon is displayed.
On RTK Mode page, in the Position submenu the line BasePilot
shows: Setting up.
4.
After the BasePilot has been completed: The position icon is
displayed. The radio/modem now starts transmitting corrections!
On RTK Mode page, in the Position submenu the line BasePilot
shows: Successful.
Step Description