User Manual
Table Of Contents
- Introduction
- Table of Contents
- 1 Unpacking the Container
- 2 Using the iCON gps 60 SmartAntenna
- 3 Leica iCON gps 60 User Interface
- 4 Software Tools
- 5 Setups with Controller and Accessories
- 6 Care and Transport
- 7 Safety Directions
- 8 Technical Data
- 9 International Limited Warranty, Software Licence Agreement
- Index
58
iCON gps 60, Software Tools
When using BasePilot, always check in the Position submenu that the
SmartAntenna has selected the correct base point! Using the wrong base
point can lead to an error of more than 20 m for a rover!
Base setup The instrument can be manually set up as a stand-alone base station without a
controller. This can be done in three different ways using the Base Setup wizard.
The wizard is accessable via Settings>Tools>Base Setup.
The first screen (Position) provides 3 functions to enter the position of the base
point:
• Get Here:
Instrument determines position and uses current position as a new base
point.
• Edit:
Manual input of coordinates to generate a new base point.
• Find Nearest:
Searches through the Base Point List for a known base point within a radius
of 20 m of the current instrument position.