User Manual
Table Of Contents
- Introduction
- Table of Contents
- 1 Unpacking the Container
- 2 Using the iCON gps 60 SmartAntenna
- 3 Leica iCON gps 60 User Interface
- 4 Software Tools
- 5 Setups with Controller and Accessories
- 6 Care and Transport
- 7 Safety Directions
- 8 Technical Data
- 9 International Limited Warranty, Software Licence Agreement
- Index
iCON gps 60, Software Tools 59
4.1.1 Base Setup Functions
Additional screens
for all functions
At the end of all base setup functions the Base Setup wizard continues with a
common set of configuration screens:
• Communication:
To configure parameters for communication with other devices.
• Antenna:
To set Antenna Type, Height and Measurement Method.
• Confirmation:
To save the current configuration to the Base Point List. Subsequently, the
instrument will start transmitting.
Function: Get Here
step-by-step
The Get Here function determines the current coordinates of the instrument and
uses this position as the base point.
Step Description
1. Position the iCON gps 60 where the base point should be set up.
2.
Highlight Modify in the Position screen and confirm selection with
key.