User Manual
Table Of Contents
- Introduction
- Table of Contents
- 1 Unpacking the Container
- 2 Using the iCON gps 60 SmartAntenna
- 3 Leica iCON gps 60 User Interface
- 4 Software Tools
- 5 Setups with Controller and Accessories
- 6 Care and Transport
- 7 Safety Directions
- 8 Technical Data
- 9 International Limited Warranty, Software Licence Agreement
- Index
60
iCON gps 60, Software Tools
3.
Select Get Here and confirm selection with key.
4. Optional for external antennas:
Set the correct Antenna Type, Height and Measurement Method in the
antenna screen.
5. When ready to determine the current position, confirm with Continue.
6. The instrument measures the current position. Subsequently it searches
the Base Point List for stored base points in the vicinity.
7. If no point is found within a 40m radius of the measured position
• use measured position
If there is already a point within a 40m radius of the measured point
• use known point (use existing) OR
• use measured position (overwrite)
8. In case the existing point has been chosen, either the saved setup can be
chosen OR the current setup.
9. Back in the Position screen:
Enter a Point ID in the Position screen and confirm with key.
10. Press right navigation key to continue with the Communication setup
screen e.g. to establish a connection via radio.
Step Description