User Manual
Table Of Contents
- Introduction
- Table of Contents
- 1 Unpacking the Container
- 2 Using the iCON gps 60 SmartAntenna
- 3 Leica iCON gps 60 User Interface
- 4 Software Tools
- 5 Setups with Controller and Accessories
- 6 Care and Transport
- 7 Safety Directions
- 8 Technical Data
- 9 International Limited Warranty, Software Licence Agreement
- Index
iCON gps 60, Setups with Controller and Accessories 79
Raw data logging
setup
step-by-step
a) iCON gps 60 antenna
b) Height hook
c) GRT146
d) Tribrach
e) Tripod
f) GEB171 external battery
g) GEV219 power cable
Step Description
1. Setting Up the Equipment
• Set up the tripod, mount and level the tribrach onto the tripod.
• Check that the tribrach is correctly centred over the marker.
• Place and lock the carrier into the tribrach.
• Screw iCON gps 60 antenna onto the carrier.
• Check that the tribrach is still correctly positioned and levelled.
If available: Else:
• Hang the external battery onto a
tripod leg.
• Use internal batterie of the
antenna without battery cabling.
• Take the GEV219.
• Attach the connectors with the
8 pin plug to iCON gps 60
antenna.