User Manual
Table Of Contents
- Introduction
- Table of Contents
- 1 Unpacking the Container
- 2 Using the iCON gps 60 SmartAntenna
- 3 Leica iCON gps 60 User Interface
- 4 Software Tools
- 5 Setups with Controller and Accessories
- 6 Care and Transport
- 7 Safety Directions
- 8 Technical Data
- 9 International Limited Warranty, Software Licence Agreement
- Index
iCON gps 60, Setups with Controller and Accessories 83
Real-time rover
setup
step-by-step
Step Description
1. Setting Up the Equipment
• Insert the battery into the iCON gps 60 antenna.
• Screw iCON gps 60 antenna onto the top of the telescopic pole.
• Ensure that the compression lock is not clamped.
• Extend the telescopic pole and ensure that the snap-lock clicks into its
position. The snap-lock ensures that there is no slipping of the tele-
scopic pole.
• Clamp the compression lock. The compression lock maintains straight-
ness.
• Fix the holder to the clamp with the tightening screw. Before tight-
ening, ensure that the holder is at a comfortable working height and
angle. This can be achieved by sliding the clamp along the pole and
rotating the holder about the clamp. Tighten the tightening screw.
• Insert the battery into the field controller.
• Clip the field controller onto the holder and lock into position.
• Turn on the antenna and the controller.