User Manual

USERS GUIDE PANMOD for FCC Description
18. Nov 2005 2 / 5
1 Description
The PANMOD is a Bluetooth Modul based on the Class 2, Panasonic Bluetooth prequallified
Standard modul PAN1440.
General PANMOD Features :
• Single 3.3V +/-5% input voltage
• -25°C to +85°C operating and -40°C to +85°C storage temperature range
• Various Software Interfaces are available : HCI, Stollmann AT, Zerial AT
• Based on Bluetooth V1.2 prequallified Class 2 PAN1440 Bluetooth modul
Bluetooth ID : B01839
• HW configurable RS232 or USB 2.0 Interface
• RS232 with UART level (3.3V)
• HW configurable for internel or externel (U.FL connector) antenna
• PI-Pad antenna matching network to adapt the internel antenna to different surroundings
• 10 pin FCC zero force connector
2 General PANMOD configuration
2.1 PANMOD Connector
CON1 Pin Signal Type Remark
1 CTS IN valid only in RS232 mode
2 RXD
USB+
IN
USB
RS232 mode
USB mode
3 TXD
USB+
OUT
USB
RS232 mode
USB mode
4 RTS OUT valid only in RS232 mode
5 RESET- IN low activ, t
activ
> 5ms
6 BBACTIV
DCD
GPIO15
OUT
OUT
I/O
H : Baseband activity (HCI)
DCD with Stollmann SPP
TBD
7 WAKEUPHOST OUT HCI : Wake up Host
8 WAKEUPBT
GPIO03
IN
I/O
HCI : Wake up Bluetooth in RS232 mode
TBD
9 VCC IN 3.3V +/- 5%
10 GND - Ground
2.2 UART - USB
With HCI software the hardware interface can be configured for USB or RS232 mode. With non
HCI Software only RS232 mode is possible.
Part RS232 mode HCI mode Remark
R2
open
1k0O USB mode
R5
open
1k5O USB mode
R7
1K0O
open RS232 mode
R13
0O
open connect RXD to CON1 Pin 2
R14
0O
open connect TXD to CON1 Pin 3
R15
open
0O connect USB+ to CON1 Pin 2
R16
open
0O connect USB- to CON1 Pin 3
bold : settings for PANMOD V3