User Manual

USERS GUIDE PANMOD for FCC General PANMOD configuration

18. Nov 2005 3 / 5

2.3 HCI WakeUp Bluetooth

When in HCI mode and the deep sleep mode is enabled this signal can be used to wake up the

Bluetooth from deep sleep mode before sending data to the UART interface. To have the ability to

define both initial state R9 and R10 are given.

2.4 HCI Base Band activ / Stollmann-SPP DCD

Part

Stollmann SPP

DCD

HCI

Remark

R3 open

GPIO_4 to CON1 Pin 6

R11

open

GPIO_15 to CON1 Pin 6

bold : settings for PANMOD V3

2.5 Antenna Type and Matching Network

To select internel or externel antenna use see table below.

Part Int. Antenna

Ext. Antenna

Remark

0.5pF

open Pi-Pad : value for Charon

10pF

open Pi-Pad : value for Charon

1.5nH

open Pi-Pad : value for Charon

ANT1

set

open Internel antenna

open

2pF U.FL selector

U.FL

open

set U.FL connector

bold : settings for PANMOD V3

2.6 LED’s

LED1 shows when lighting the running state of the ARM7 processor.

LED2 shows in HCI mode the state of the base band activity.