User Manual

18. Nov 2005
I:\GPS\Charon\Hardware\Bluetooth\PANMOD\General Doku\USERS GUIDE PANMOD for FCC.doc
5 / 5
4 FCC Compliance
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
4.1 Labeling Requirements for End Product
The PANMOD is labled with it’s own FCC ID number RFD-PANMOD1.
For the end product which contains the PANMOD V3 there must be a lable containing, at least the
following information :
This device contains FCC ID: RFD-PANMOD1
The label must be affixed on an exterior surface of the end product such that it will be visible upon
inspection in compliance with the modular approval guidelines developed by the FCC.
In addition, the user manual for the end product must contain the following information:
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
4.2 RF-exposure Statement
The antenna shown in this filing must not be co-located or operated in conjunction with any other
antenna or transmitter. End users may not be provided with the module installation instructions.
OEM integrators and end users must be provided with transmitter operating conditions for
satisfying RF exposure compliance.
For portable applications OEM integrators need no SAR evaluation. The max source-based time-
averaged output of 1.17 mW is below the low threshold of 24mW for d < 2.5 cm.
Use only the supplied or approved antenna. Unauthorized antennas, modifications or attachments could
damage the terminal and may contravene local RF emission regulations or invalidate type approval.