User Manual

EN
20
Basic camera settings
PRESETS
CAMERA DEFAULT SETTINGS
Menu language
The language used in the default setting of the menu control is English.
German, French, Italian, Spanish, Russian, Japanese, Chinese Trad.,
Chinese Simp., Korean and Portuguese can also be selected as alterna-
tive menu languages.
Setting the function
1. In the menu, under SETUP , select the item Language and
2. select the desired language in the sub-menu.
• Apart from a few exceptions (button names, short designations),
all linguistic information changes.
Date and time
Date
There are 3 options available for the sequence of the date.
Setting the function
1. In the menu, under SETUP , select the item Date & Time and
2. call up the sub-menu
3. Select
Date Setting and call up
the corresponding sub-menu
4. To change the representation,
Day/Month/Year, Month/Day/Year, or
Year/Month/Day, press the Joystick up or down or turn the rear
thumbwheel with the header line active.
5. Pressing the Joystick to the left or right takes you out of the marked
header line to the three setting fields below, or back to the header
line.
6. In the respective marked setting field, make the settings by pressing
the Joystick up or down or by turning the rear thumbwheel.
7. Confirm and save the settings by pressing the button marked
OK in
this case at the bottom right next to the monitor
Time
Setting the function
In sub-menu item Time Setting the settings are made for both the numeri-
cal groups and for the representation in essentially the same way as
described in the previous section for the date.
Of the other three items in the
Date & Time sub-menu, Auto GPS Time and
Daylight Saving Time are activated or deactivated by pressing the rear
thumbwheel or the Joystick forward or to the right, while under
Time Zone
the desired location is selected from the list in the corresponding menu
by turning the rear thumbwheel or pressing the Joystick up or down.
Notes:
•
Auto GPS Time is only available when the GPS function is switched on,
Time Zone and Daylight Saving Time are only available when the GPS
function is switched off.
• Even if no battery is inserted or the battery is discharged, the date and
time settings are retained for roughly three months by an integrated
back-up battery (see also "Charge level displays"). After that period,
however, the date and time must be set again as described above.
Auto power OFF
This function turns the camera off automatically after a preset time. This
state corresponds to the main switch position
Off.
Setting the function
1. In the menu, under SETUP , select the item Auto Power Saving and
2. set the desired time
Note:
Even if the camera is in standby mode, i.e. the displays have gone out or
the activated
Auto Power Saving function has turned it off, it can be
reactivated at any time by pressing the shutter button.
Inhalt_EN.indd 20 12.10.2015 09:34:14