User Manual

EN
48
Review mode
VIEWING OTHER PICTURES / SCROLLING
1
2
Turning the rear thumbwheel allows you to select other pictures.
Turning to the left takes you to the pictures with lower numbers,
turning to the right to the pictures with higher numbers. After reaching
the highest and lowest
numbers, the series of the pictures arranged in an endless loop
starts again from the beginning so that you can reach all the
pictures in both directions.
The picture and fi le numbers in the monitor change accordingly.
Note:
This is possible in all review modes, at all zoom levels, including off -cen-
ter details, and during the simultaneous review of several reduced pic-
tures.
ENLARGING THE DETAIL
You can enlarge a detail of the picture
in steps
or
call up the highest possible enlargement in one step.
Enlarging in steps
The displayed detail can be enlarged by turning the shutter speed setting
dial to the right. The further you turn, the greater the enlargement and
the smaller the detail. Enlargement is possible in 4 steps until 1 pixel of
the monitor displays 1 pixel of the picture.
The displays in the header and the symbols for the functions of the
keys and thumbwheels disappear. The rectangle inside the frame
shows the size and position of the detail.
Maximum enlargement in one step
Holding the rear thumbwheel depressed (≥1s) switches between the
review of the whole picture and maximum enlargement.
Note:
The function is available at all zoom levels. If a detail was previously
displayed, pressing the fi rst time displays the whole picture again.
Inhalt_EN.indd 48 12.10.2015 09:34:21