Item Brochure

Leica Digitex Signal Transmitters
Direct Connection
Connect the Digitex to a
conductive utility such as a valve,
stop tap or other access point.
Signal Clamp Connection
A signal clamp is used to apply the
Digitex signal to a pipe or live
electricity cable. Supply is not
interrupted by the signal and the
operator is not exposed to any live
utility.
Induction
The Digitex induces a tracing signal
into the buried pipe or cable. This is
a quick and convenient method
when direct connection or signal
clamping is not possible.
Leica Digitex signal transmitters
deliver significantly higher power
than previous models. This improved
performance will allow users to:
 Trace utilities over a greater
distance
 Improve utility detection in areas
of high signal interference
 Improve depth estimation when
using a depth locator
Quick
reference
guide
Accessory
storage
compartment
Battery
compartment
User controls
Features Digitex 100t
Article no. 795946
Digitex 300t
Article no. 798651
8 kHz Mode
8.192 kHz 8.192 kHz
33 kHz Mode
32.768 kHz 32.768 kHz
Mixed 8/33
8.192 kHz/32.768 kHz 8.192 kHz/32.768 kHz
Induction (Max)
Up to 1W max Up to 1W max
Direct connection (300 Ohms)
Up to 1W max when connected to a buried
utility with an impedance of 300 Ohms
Up to 3W max when connected to a buried
utility with an impedance of 300 Ohms
Protection (case lid closed)
IP67 IP67
Working temperature
–20°C to +50°C –20°C to +50°C
Battery type
4 x D alkaline (IEC LR20), supplied 4 x D alkaline (IEC LR20), supplied
Battery life (typical use at 20°C)
30hrs intermittent use 20hrs intermittent use
Weight
2.5kg/5.5lbs including batteries 2.5kg/5.5lbs including batteries
Dimensions
113mm (H) x 206mm (D) x 250mm (W) 113mm (H) x 206mm (D) x 250mm (W)
Extended self test
Induction and Connection Modes Induction and Connection Modes
Power output levels
4 4