User's Manual

6 Care and Transport
6.1 Maintenance
For units that are exposed to high mechanical forces, for example through
frequent transport or rough handling, it is recommended to carry out test
measurements periodically.
Inspect the cables regularly. In case the insulation is damaged, replace the
cables immediately.
CAUTION
Unapproved supply or cables
Connecting the supply improperly may cause serious damage to the device.
Any damage caused by misuse is not covered by the warranty. Unapproved
supply or cables can damage the device.
Precautions:
▶
Use only Leica-approved supply and cables.
6.2 Transport
When transporting the equipment in the eld, always make sure that you carry
the product in its original container.
Never carry the product loose in a road vehicle, as it can be affected by
shocks and vibrations. Always carry the product in its container and secure it.
For products for which no container is available use the original packaging or
its equivalent.
When transporting the product by rail, air or sea, always use the complete
original Leica Geosystems packaging, container and cardboard box, or its equi-
valent, to protect against shock and vibration.
6.3 Storage
Respect the temperature limits when storing the equipment, particularly in
summer if the equipment is inside a vehicle. Refer to 7 Technical Data for
information about temperature limits.
•
Keep AC/DC power supply away from excessive dirt, dust and contamin-
ants
•
After unpacking the product visually inspect the supply for possible dam-
age
•
Unplug the product from the outlet before attempting any maintenance or
cleaning
6.4 Cleaning and Drying
Dry the product, the transport case, the foam inserts and the accessories at a
temperature not higher than 40°C /104°F and clean them. Do not repack until
everything is completely dry. Always close the transportation case when using
in the eld.
☞
☞
Transport in the eld
Transport in a road
vehicle
Shipping
BLK ARC
AC/DC power supply
Damp products
26 Care and Transport