User's Manual
Table Of Contents
- Congratulations!
- Safety and Use
- Leica EZ4, Leica EZ4 E or Leica EZ4 W
- Eyepieces (Only for Leica EZ4)
- Photography Using the Leica EZ4 E or Leica EZ4 W
- Get Set!
- USB Mode – Capturing and Adjusting Images Using a Computer
- SD Mode – Capturing Images Without a Computer or Without a Wireless Device
- Adjusting Settings While in SD Mode
- WiFi Mode – Capturing and Adjusting Images Using a Wireless Device (Only Available for Leica EZ4 W)
- Ethernet Mode – Capturing and Adjusting Images Using a Network
- The Camera Remote Control (Optional)
- Care, Transport, Contact Persons
- Specifications
- Dimensions
Leica E Series User Manual Get Set! 42
In order to use this mode, you must
have an SD card (not provided) with free
memory on it. If the SD memory card is full, the
capture button LED will not light green and you
will not be able to capture any more images.
Attaching the power cable
1. Switch on the power to the EZ4 E or EZ4 W
microscope.
2. The status light will blink red. Wait until
the status light is green and one of the
mode button's is also green. This may take
approximately 30 seconds.
SD Mode – Capturing Images Without a Computer or Without a Wireless Device
3. If a mode button other than SD mode is lit
green, then press the SD mode button and
wait until both the status LED and the SD
mode button is green.
4. Insert the SD memory card into the slot on
the side of the Leica EZ4 E or EZ4 W until the
card clicks into place.