Operation Manual

Rugby 670/680, Operation
20
Grade mode screen
3.3 Grade Entry
Entering grade
Enter your desired grade in Grade mode. The
Rugby 670/680 will check the level position
and then adjust the plane of laser light to the
grade input.
In Grade mode, the Rugby 670/680 does not
self-level, but is set to detect bumps and
temperature changes.
A small icon in the bottom left corner of the
screen indicates that the axis with grade is
not self-levelling.
Rugby 670
Rugby 680
006057_001
006056_001
The Rugby 670/680 always starts up with no
grade input.
To enter grade, do the following:
1) Press the Grade button once to enter
Grade mode.
2) Press the Up and Down arrow buttons to
enter a grade for the X-axis.
3) Rugby 680 only: Press the Grade button a
second time to switch to the Y-axis.
4) Rugby 680 only: Press the Up and Down
arrow buttons to enter a grade for the Y-
axis.
5) Press the Grade button again to return to
the Main user screen.
The Rugby will begin the grade setting
process.

The smallest grade increment is 0.05%
up to 3.00% grade and 0.10% for
grade greater than 3.00%.

When entering grade the displays
change as shown.

To restore the last set grade(s), press
and hold the Grade button for
1.5 seconds.

If after eight seconds no button is
pressed, the Rugby will accept the
grade entered and will begin the grade
setting process.
Rugby 670: X-axis entry
Rugby 680: X-axis entry
Rugby 680: Y-axis entry
006043_001
006041_001
006042_001