Operation Manual

Rugby 670/680, Troubleshooting
38
8Troubleshooting
Alerts
Alert Symptom Possible causes and solutions
Low Battery indication on the
display.
The batteries are low. Replace the
alkaline batteries or recharge the
Li-Ion battery pack. Refer to "6
Batteries".
Elevation (H.I.) Alert
The Elevation (H.I.) Alert screen
is shown and the audio beeps.
(Level position)
The Rugby has been bumped or
tripod was moved. Turn off Rugby
to stop alert, check the height of
the laser before beginning to work
again. Allow Rugby to re-level and
check the height of the laser.
After two minutes in the alert
condition, the unit will shut off
automatically.
Bump Alert
The Bump Alert screen is shown
and the audio beeps.
(Grade position)
The Rugby has been bumped or
tripod was moved. Turn off Rugby
to stop alert, check the height of
the laser before beginning to work
again. Allow Rugby to re-level and
check the height of the laser.
After two minutes in the alert
condition, the unit will shut off
automatically.
Servo Limit Alert
The Servo Limit Alert screen is
shown.
The Rugby is tipped too far to
reach a level position. Re-level the
Rugby within the 6 degree self-
levelling range.
After two minutes in the alert
condition, the unit will shut off
automatically.
Tilt Alert
The Tilt Alert screen is shown.
The Rugby is tipped more than
45° from level.
After two minutes in the alert
condition, the unit will shut off
automatically.
Smart Slope Alert
The Smart Slope Alert screen is
shown.
The Rugby is checking the level
position before returning to
grade.
Refer to "Smart Slope".
Temperature Alert
The Temperature Alert screen is
shown.
The Rugby is in an environment
where it cannot operate without
causing damage to the laser
diode. This could be a result of
heat from direct sunlight. Shade
the Rugby from the sun.
After two minutes in the alert
condition, the unit will shut off
automatically.
006045_001
006046_001
006141_001
006143_001
006047_001
006142_001