Operation Manual

- 175 -
Message displays
[Memory card parameter error]
●
The card is not of SD standard.
●
With capacities of 4 GB or more, only SDHC or SDXC Memory Cards are supported.
[Read Error] / [Write Error] [Please check the card]
●
Reading the data has failed.
→ Check whether the card has been inserted correctly (→19).
●
Writing the data has failed.
→ Turn off the power and remove the card, before re-inserting and turning on the power again.
●
The card may possibly be damaged.
●
Try with a different card.
[Cannot record due to incompatible format(NTSC/PAL) data on this card.]
●
Format the card after saving necessary data on a PC etc. (→60)
●
Insert a different card.
[Motion recording was cancelled due to the limitation of the writing speed of the card]
●
If recording stops even when using a card of the recommended speed class (→20), the data writing
speed has dropped. If this happens, we recommend backing up the data on the memory card and
formatting it (→60).
●
Motion picture recording may be automatically terminated with certain cards.
[A folder cannot be created]
●
The folder numbers in use have reached 999.
→ Save the needed data on a computer or an other device, and then use [Format] on the camera.
(→60)Folder number is reset to 100 when performing [No.Reset] (→58).
[Picture is displayed for 16:9 TV] [Picture is displayed for 4:3 TV]
●
The camera is connected through the supplied AV cable.
→ To remove a message immediately → Press [MENU/SET].
→ To change an aspect ratio → Change [TV Aspect] (→59).
●
The USB connection cable (supplied) is only connected to camera.
→ The message disappears when the cable is also connected to another device.
[This battery cannot be used]
●
Use a genuine Leica battery.
●
The battery cannot be recognized as its terminals are dirty.
→ Wipe any dirt away from the battery terminal.
[GPS feature is not available in this region.]
●
GPS may not work in China or in the border regions of countries neighboring China. (Current as of
December 2011)
[Recording failed.]
●
Recording may be impossible if the recording location for a 3D image is too dark/too bright, or if the
subject lacks contrast.